When to Use Zigzag Springs in Upholstery

When to Use Zigzag Springs in Upholstery

  • By :
  • Category : Home
  • Comment : 0
When to Use Zigzag Springs in Upholstery

A reupholstery job may seem like plenty of work, but it may give you an awareness of creative accomplishment when you finish the job. After removing the cloth at the seams — use the previous pieces since the pattern for cutting new ones — the dust cap and cushion fabric, check the springs to find out if they need replacing. When the springs appear bent or stretched out, then replace them. Zigzag springs, also called sinuous or even S-springs, are different from coil springs; they lay flat and are commonly found in more modern furniture.

Zigzag Springs

Made from two-dimensional S-shaped heavy-duty cable, Sliding springs have been known in the upholstery sector as “No-Sag” springs. Modern producers have turned to using zigzag springs in upholstered furniture since they’re affordable and easy to install. You may use zigzag springs in ottomans, couches and chairs. But they work best in furniture pieces with shallow frames. Deep-framed antique upholstered furniture pieces are generally designed to use coil springs and webbing.

Sofas and Chairs

Fastened with clips and nails which do not sag, zigzag springs attach leading to back to encourage the seat, and from top to bottom to form chair and sofa backs. You do need to tie the person springs jointly from side to side about 1 1/2 inches past where they link to secure them, but they do not call for a tedious hand-tying job like coil springs perform.

Firmness and Gauge

Zigzag springs may replace coil springs provided that you pay attention to thegauge of the cable and the stability of the spring. You normally purchase the springs needed in 10-foot sections, and trim them together with wire cutters. Firm sinuous springs — 8 or 9 gauge — work best for seats and ottomans. Gentle, or 11-gauge, sinuous springs are intended for seat and sofa backs. You need two clips to attach each spring to the framework, spaced roughly two inches apart.

The Gold Standard

Coil springs tied in eight instructions and supported with webbing represent the gold standard when reupholstering. These springs produce the most stability and endurance in the seat since they distribute body weight more evenly than zigzag springs. These kinds of springs have an hourglass or cylindrical form. Tying them together in eight different directions — called the eight-way hand-tie — ensures the support for the seat maintains the tension required.

The Reupholstery Rule

The general rule when doing a reupholstery job is to place the exact things into the support area of the furniture which you took out. Even though you are able to substitute zigzag springs for coils, then this might not give the couch or seat exactly the exact same profile that it had with the original springs. The arrangement of the springs, tying and webbing ascertain the muscles of the seat. If you don’t complete this step correctly, your chair or couch might not have the form you desire.

hily1970