How to Make a Pendant Light Plug Into a Wall Outlet

How to Make a Pendant Light Plug Into a Wall Outlet

How to Make a Pendant Light Plug Into a Wall Outlet

A pendant — hanging — lighting is designed for hard-wiring into a ceiling electrical box so you can control it using a wall switch. If you would rather hang the lighting from a hook, suspend it over a favourite chair or table and plug it into a wall socket, you need to splice a plug onto it. You can buy a plug attached to a cord for this use, or you can simply cut the plug in and a length of cord from a castoff appliance. The plug should be three-prong or polarized — just one prong wider than another.

Disconnect the light from the circuit to which it’s connected by shutting off the breaker, taking away the canopy to detect the electrical box and separating the wires. Take the lighting down. Remove the lights and lay it on a table.

Disconnect the canopy from the chain, and slip the canopy up and off the end of the wire. Discard it or save it for a different project.

Snip the wires back to your point about 2 inches until they enter the sheathing that goes to the lamp, using wire snippers. Remove 1/2 inch of insulation from each of the wires, using cable strippers. You should see two wires — a black one and a white one — and, perhaps, a Landscaping design Flagstaff, AZ cable that is bare or coated with green insulation. If the lamp has a Landscaping companies Fort Lauderdale, FL cable, you will need to link it to your three-prong plug. Otherwise, you can use a two-prong, polarized plug.

Prepare the cable on the plug in stripping insulation from the finish, if necessary. If the plug has three prongs, you will see black, white and green wires inside the sheathing. When it’s a two-prong, polarized plug, you will see only two wires, and they will be individually coated with insulating material. The insulating material on the neutral wire is either ribbed or it bears a white line. The insulation in the hot cable does not have any distinguishing features.

Slide a 4-inch length of heat-shrink tubing across the plug cord far enough to get it out of the way. It will pay for the splice after you have finished making connections.

Crimp a heat-shrink butt splice connector onto the end of each cable, using pliers to secure the crimps. Use male connectors on the wires on the plug, and female connectors on those attached to the lamp.

Catch the straps together and, once you’re sure the connections are protectedand heat the shrink wrap using a hair dryer set to its highest heat setting. Keep hot air on the straps until you actually see them shrink. Allow the connectors cool before proceeding.

Slide the tube along the cord and insert it over the link. Shrink it using the hair dryer in precisely the exact same manner you shrunk the straps.

Hang the lamp out of a hook in the ceiling or wall and plug it to the nearest socket.

hily1970