The way to Add a Washer Drain

The way to Add a Washer Drain

The way to Add a Washer Drain

The drain for the washing machine is referred to as a standpipe, and it’s usually a span of 2-inch ABS pipe which goes vertically along the wall behind the washer. The requirements for a standpipe are essentially the same as they are for installing a sink drain — the standpipe has to be connected to your P-trap, and the trap has to be vented. Moreover, relates InspectAPedia, the El Paso AC repair specialists code specifies that the maximum height for the trap weir, and minimum and maximum heights for your standpipe opening. You do not have to cover the standpipe opening; the drier hose hooks to it.

Find an appropriate place to tie to your major drain, and put in a 2-inch wye fitting or a 2-inch sanitary tee. The tee is suitable if the angle of this drier drainpipe is vertical to the main drain. If the 2 pipes operate parallel to one another, use the wye.

Install the fitting by cutting on the main drain pipe with a hacksaw and solvent-welding the fitting with plastic pipe cement. Expand 2-inch pipe from the fitting socket into the place of this standpipe, gluing the fittings as you proceed. Maintain a 1/4-inch-per-foot downward incline on the pipe.

Paste a 2-inch sanitary tee to the end of the drain to your vent pipe. Its outlet should be facing up. This fitting must be within 5 feet of this trap weir, that is the point where the trap begins to bend.

Expand the port vertically in the elbow to a handy tie-in place to another port — you might need to stretch the port through the Landscaping design Cape Coral to create this connection. Use a port tee to connect both ports.

Position the trap at the best place inside or away from the wall behind the washing machine, and connect it into the left elbow by gluing on the other length of pipe. Secure the trap into the framing with pipe bunker. It ought to be no greater above the Landscaping near me Salt Lake City, UT than 12 inches.

Fit the standpipe, which is a span of 2-inch pipe, in the trap inlet and secure it with glue. The open end of the standpipe has to be between 30 and 48 inches above the Landscaping cheap Salt Lake City, UT.

hily1970